Portable Indicator for VW Sensors

Model EDI-54V Overview

Model EDI-54V indicator is an advanced readout unit/logger which can be used to log data from vibrating wire sensors. It can be store calibration coefficients of more than 10,000 vibrating wire sensors so that the value of the measured parameter from the sensors can be shown directly inproper engineering units. For sensors provided with an internal YSI 44005 or equivalent 3 k0hms thermistor, the sensor temperature is displayed directly in degree Centigrade or Fahrenheit. The indicator has an internal non-volatile memory with sufficient capacity to store about 525,000 readings while scanning from any of the programmed transducer. Each reading in stamped with date and time.

Model EDI-54V indicator uses a smartphone with Android OS as readout with a user friendly software for configuration, retrieving and viewing sensor data.The phone running on Android operating system provides a powerful platform to manage our configuration application efficiently. Since readout unit is a mobile phone, its operation is user friendly and convenient.

The huge computational and image processing power of smartphone allows the application to display the logged data as tables and graphs and keep a record of previous data. This allows the operator to verify the logged data and investigate any anomaly immediately at site. The measured reading can be viewed in terms of time period, frequency, frequency squared or directly in relevant engineering units.

Specifications

Input

Suitable for input from all two wire vibrating wire transducers with 110 to 150 Ohms (nominal) sensor coil. Thermistor input from sensors provided with integral 3 kOhm (@ 25°C) R-T curve matched YSI 44005 or equivalent thermistor.

Excitation

Swept frequency excitation, 5 V (typical) peak to peak square wave.

Frequency measurement

Range:
500 - 5000 Hz 
Measurement time:
128 cycles
Measured parameter:
Time period
Resolution:
0.01 micro-seconds (in time period display mode)
Accuracy:
Period measurement ± (0.006% of reading + 0.004µsec)
Displayed parameters:
Time period, frequency, frequency squared and engineering units.
Measurement range:
-20 to + 100°C
Resolution:
1°C


Memory : 64 Mb flash memory.

The indicator has an internal non-volatile memory with sufficient capacity to store about 525,000 readings from any vw sensor, with date and time.

Real time clock

A real time clock is provided for time and date stamping of stored data.

RTC time keeping accuracy: ± 30 seconds/month, typical, over the operating temperature range with indicator powered on.

Input/output connectors

Circular splash proof 7-pin connector for sensor input and 6-pin connector for battery charger.