search

Portable Indicator for Analog Sensors

Model EDI-53 Overview

Encardio-rite model EDI-53 series readout units is a micro-processor based read out unit which can be used with various type of sensors, like those with voltage output, current output, etc. The readout unit can display the measured parameter directly in applicable engineering units. Potentiometric and resistance strain gage based geotechnical transducer from most other manufacturers can also be read by the EDI-53.

The readout unit is available in following variants:

·         EDI-53P for potentiometric displacement transducers with voltage output

·         EDI-53L for resistive strain gage load cells

·         EDI-53I for 4-20 mA DC current output transducer

·         EDI-53UTM for tilt meters with voltage output

·         EDI-53UTM-C for electrolytic level type tilt meters

Model EDI-53 digital indicator can store calibration coefficients of maximum 250 numbers of transducers. It can store either around 3600 readings from any one transducer or about 14 sets of readings from all the 250 transducers. Each reading is stamped with date and time at which the measurement was taken.

The EDI-53 digital indicator is housed in a light weight splash proof plastic moulded enclosure with weather proof connectors for making connections to the transducer and the battery charger.

Specifications

Model EDI-53P

Input: Potentiometric displacement transducers with 0-2 V DC output.

Excitation voltage: 5 V DC

Model EDI-53L

Input:  Resistance strain gauge bridge load cell with 0…3 mV/V output.

Excitation voltage:   5 V DC

Min. L/C input resistance: 90 Ohms Preamplifier gain 100

Model EDI-53I

Input: 4-20 mA DC current input.

Input resistance: 50 ohms

Model EDI-53UTM

Input: Uniaxial tilmeter; 0-4 V DC output

Excitation voltage: 12 V DC (nominal)

Model EDI-53ELV

Input: EL tilt meter (voltage output)

Excitation voltage: 12 V DC (nominal)

Portable Indicator for analog sensors
Portable Indicator for analog sensors